Skip to main content
contact
cart
our twitterour facebook page
Sponsored forums

2011 - 2014 Mustang 5.0 GT Engine Cover Bundle Trim Kit - Laser-Cut Mirror Stainless Steel
Price:
$89.99
 
Details:

All 4 of our stainless front trim accents sold in a bundle at a discounted rate - the ultimate touch to fill the stamped "32V TiVCT" text, strips to fill the driver and passenger side engine cover recessions, and fill the 2 recessed areas with our trim rings on your 2011 - 2012 engine cover. These pieces are laser-cut from 18ga mirror stainless steel (20ga for the front trim).  They will never rust, peel, or oxidize. These pieces adhere with pre-applied 3M double-sided tape; just clean the area, peel the liners and stick them into place.

Note: The front trim piece follows a bend in the factory engine cover.  Proper cleaning is necessary for proper adhesion. This piece is also going to require that you pre-bend and manipulate the metal for fitment prior to installation to alleviate stress on the piece and ensure adhesion. The metal is easily bent into shape using your hands and the engine cover as a guide.

Additional photos are shown in the additional pictures link below the main picture above. Some pictures are of a brushed finish material.

These pieces are also available in a brushed stainless steel as well.  Just be sure to check if you would like brushed finish at the bottom of this screen.

Select Finish
*
Quantity
add to cart buy now
Customer Reviews
5 star 
 
 100%
4 star 
 
 0%
3 star 
 
 0%
2 star 
 
 0%
1 star 
 
 0%
Average Review
  • Currently 3/5 Stars.
5 out of 5
1 Customer Ratings
Finish what Ford started
  • Currently 3/5 Stars.
Rating 5/5
This is what your engine cover should have looked like from the start - really improves an already great looking cover! Took about 30 minutes from start to finish. All fit pretty good - I had to use some two part epoxy on the front trim ring near the bottom for it to seat in the recess. All the letters fit great with the exception of the "i" - did not want to center so I used some epoxy on this as well(use some on the dot as there is not much tape on this small piece). The strips for the top recesses fit perfectly. Adds just the right amount of bling without being over the top. High quality material and has a really nice finish. Highly recommended if you like to show your car!
Posted by Don C Verified Buyer
12/20/2014 - 10:35 PM
View all  Create your own review