GM Official Licensed Product
This is a Stainless Steel, laser-cut Shield, available in mirror or brushed finish, that fits onto the protrusion in your hood insulation. This listing includes "CAMARO" permanently laser-etched onto the Shield Logo.
The colored sections are adhered to the reverse side of the Shield Logo, and they are mirror acrylic red, high gloss white, and mirror acrylic blue.
As a standard this piece will mount with 4 chrome-plated, allen-keyed, button-head bolts along with matching fastening hardware.
Installation Instructions (Approximately 20 minutes):
1 - Remove hood liner by removing the plastic retaining pins.
2 - Once the hood liner is removed, place the stainless Shield logo into position and mark the 4 bolt holes using a paint marker.
3 - Remove the Shield and pierce your marked areas of the hood liner with a knife in an "X" patter for each hole.
4 - Position the Shield logo and insert each bolt and loosely snug them down until all four bolts begin to thread.
5 - Individually tighten the bolts ensuring proper position of the Shield as you go.
6 - Place hood liner back into place, and replace the retaining pins you removed in step one.